Brass fittings
Brass Compression Elbows and Tees for PE (PN25)
Range of compression elbows and tees, manufactured entirely in brass for creating changes of direction and branches on polyethylene (PE) pipes. Designed for high pressure (PN25), they guarantee maximum robustness and reliability at the most critical points of the pipeline.
- 78references
- 15 – 110 mmsize range
- 78in stock
This range of brass compression elbows and tees is the professional solution for laying out complex polyethylene (PE) pipe runs without sacrificing strength. Manufactured entirely in solid brass, these fittings offer far superior safety and durability compared with plastic alternatives, especially in installations subject to high pressure, vibration or mechanical stress.
Each piece, whether a 90° elbow or a branch tee, is designed to withstand a nominal pressure of 25 bar (PN25). The compression joint system, with its NBR O-ring and brass grip ring, ensures a completely watertight connection with a mechanical grip that prevents any movement of the pipe.
They are the ideal components for configuring irrigation headworks, water service connections or industrial circuits, allowing angles and branches to be created with complete confidence that the joint will be the strongest point in the network.
- Material
- Brass in all components (body, nut and grip ring).
- Sealing gasket
- NBR O-ring for a perfect seal.
- Nominal pressure
- PN25, ideal for demanding installations.
- Pipe connection type
- Mechanical compression.
- System connection
- Male or female thread (BSP) depending on model.
- Compatible pipe
- Polyethylene (PE, HDPE, LDPE).
- 90° elbows with female thread
- For Ø20 mm PE pipe - ½" threadWeight 261 g
- For Ø25 mm PE pipe - ¾" threadWeight 346 g
- For Ø32 mm PE pipe - 1" threadWeight 544 g
- 90° elbows with male thread
- For Ø20 mm PE pipe - ½" threadWeight 215 g
- For Ø25 mm PE pipe - ¾" threadWeight 312 g
- For Ø32 mm PE pipe - 1" threadWeight 482 g
- 90° tees with female centre outlet
- For Ø20 mm PE pipe - ½" threadWeight 324 g
- For Ø25 mm PE pipe - ¾" threadWeight 452 g
- For Ø32 mm PE pipe - 1" threadWeight 727 g
Full dimensions and weights in the Technical data sheet (PDF).
- Changes of direction90° elbows are perfect for following walls and corners or for configuring chambers.
- Creating branchesTees allow branches to be created for different irrigation sectors, water points or production lines.
- Manifold assemblyIdeal for building compact, robust manifolds for groups of solenoid valves.
- Compressed air installationsThe robustness of brass makes them perfect for air lines in workshops and industry.
- Critical pointsIn any installation where a plastic elbow or tee could be a weak point, these brass fittings guarantee maximum safety.
References
Brass fitting
Type
Pipe Ø
Thread
No references match the filters.
